FREQUENTLY USED · Protocol

Modbus

A simple, widely used protocol for reading and writing values in controllers, meters and drives.

The background is a map of DNT's six areas and the connections between them. Digital Products is connected to Software & AI. Software & AI is connected to Digital Products, Connected Systems, Automation & CTS and R&D. Connected Systems is connected to Software & AI, Automation & CTS and Hardware & Machines. Automation & CTS is connected to Software & AI, Connected Systems and Hardware & Machines. Hardware & Machines is connected to Connected Systems, Automation & CTS and R&D. R&D is connected to Software & AI and Hardware & Machines. This page belongs to Connected Systems and Automation & CTS.

What it is

Modbus is a client/server protocol, first published in 1979, used over serial lines (Modbus RTU) and Ethernet (Modbus TCP) to read and write registers in PLCs, meters, drives and sensors.

Where we use it

We use Modbus often to read and write values in heat pumps, meters, drives and controllers - in HVAC and in automation and plant control in general, also when the data goes on to remote monitoring. How much depends on the project.

Honestly

Is it the right choice?

When it fits

When a device has a fixed set of registers to be read or set simply and reliably.

When it does not

When data has to cross an open network without extra protection: classic Modbus has neither encryption nor access control.